lyophilized powder is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2026-05-16. Where a claim depends on a specific study, the study is described rather than over-claimed.
纯度评估以反相高效液相色谱为主，通过主峰面积百分比给出粗略结果，再配合电喷雾质谱核对分子量。氨基酸分析可验证组成比例，手性色谱或毛细管电泳用于检查残基构型。常见杂质包括缺失序列的短肽、氧化产物与二聚体。由于多数市售品不附带完整检验报告，独立第三方检测常被用来核实标称值。
从分子层面看，Semax 是线性七肽，没有二硫键、糖基或脂链修饰，N 端为游离氨基，C 端为游离羧基。分子含组氨酸与谷氨酸侧链，因此在水和甲醇等极性溶剂中溶解良好，在非极性溶剂中溶解有限。计算分子量约为 814 Da，与其质子化离子的质荷比吻合，可用于质谱确认。
Solid material is normally kept at minus 20 degrees Celsius in a sealed, desiccated container. Reconstituted solutions are less stable and are usually divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and loss of activity. Light exposure is minimized by using amber glassware or foil wrapping. Published stability data for this peptide are sparse, so recommended storage conditions rest mainly on general practice for short synthetic peptides rather than on dedicated study.
Identity and purity are commonly assessed by reversed-phase high-performance liquid chromatography, with ultraviolet detection near 214 nanometers for the peptide backbone. Mass spectrometry, either electrospray or matrix-assisted laser desorption, confirms molecular mass and detects truncation or modification products. Amino acid analysis can verify composition. Because the sequence contains no strongly absorbing aromatic residue apart from phenylalanine, detection wavelengths are chosen carefully. Purity values above 95 percent are typical for research-grade material.
| Property | Value | Notes |
|---|---|---|
| 分子式 | C37H51N9O10S | 游离碱形式 |
| 等电点 | 约 6.5 | 估算值，随缓冲体系变化 |
| 主要降解途径 | 水解与氧化 | 侧链氧化最为常见 |
| 溶液储存 | 2 至 8 摄氏度避光 | 避免反复冻融 |
| 常规分析手段 | 反相色谱与质谱联用 | 氨基酸分析辅助核对 |
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
An RF value will always be in the range 0 to 1; if the substance moves, it can only move in the direction of the solvent flow, and cannot move faster than the solvent. For example, if particular substance in an unknown mixture travels 2.5 cm and the solvent front travels 5.0 cm, the retardation factor would be 0.50. One can choose a mobile phase with different characteristics (particularly polarity) in order to control how far the substance being investigated migrates. An RF value is characteristic for any given compound (provided that the same stationary and mobile phases are used). It can provide corroborative evidence as to the identity of a compound. If the identity of a compound is suspected but not yet proven, an authentic sample of the compound, or standard, is spotted and run on a TLC plate side by side (or on top of each other) with the compound in question. Note that this identity check must be performed on a single plate, because it is difficult to duplicate all the factors which influence RF exactly from experiment to experiment.
HOCH(CH2OH)2 + HCl → HOCH(CH2Cl)(CH2OH) + H2O The same compound can be produced by hydrolysis of epichlorohydrin. Epoxidation by reaction with epichlorohydrin and a Lewis acid yields Glycerol triglycidyl ether.
1915–1917 Experiments to find out the effects of food restriction on the life duration of rats, conducted by Thomas Osborne. Apparently, these were the first systematic experiments in this direction. These experiments remained little known. The method was popularized by Clive McCay in 1934–1935 (see further). 1910s–1930s Austrian physiologist Eugen Steinach was trying to achieve rejuvenation effects by means of different surgical operations such as partial vasectomy for men, ligation of fallopian tubes for women, transplantation of testicles, etc. And although later these operations were found to be ineffective, they allowed the researchers to recognize the role of the sexual glands and sexual hormones in the formation of the first and secondary sex characteristics, enriched physiology, laid the foundation for the science of sexology, formed the basis for sex reassignment surgeries. From 1921 to 1938, Eugen Steinach was nominated for the Nobel Prize many times (according to various sources, from 6 to 11 times), but never received it. 1910s–1930s Numerous experiments for obtaining rejuvenating effects by means of transplantation of organs and tissues. Among the most notable researchers who worked in this direction, there were Alexis Carrel (who developed the technology of anastomosis of blood vessels and advanced asepsis, a Nobel laureate of 1912), Mathieu Jaboulay, Emerich Ullmann, Jacques Loeb, John Northrop, Porfiry Bakhmetiev.
uridine (U, Urd) One of the four standard nucleosides used in RNA molecules, consisting of a uracil base with its N9 nitrogen bonded to the C1 carbon of a ribose sugar. In DNA, uridine is replaced with thymidine.
Sources: en.wikipedia.org
==== Physiological effects ==== Angiotensin II exhibits endocrine, autocrine/paracrine, and intracrine functions. It promotes aldosterone release from the adrenal cortex, as well as arginine vasopressin release from the posterior pituitary. It acts directly upon the proximal tubules of the kidney to regulate water and Na+ reabsorption, promoting reabsorption at very low concentrations while increasingly inhibiting reabsorption with increasing concentrations. In the proximal tubule, it promotes Na+ reabsorption and H+ excretion (which is coupled to bicarbonate reabsorption) by the Na+/H+ exchanger. It causes venous and arterial vasoconstriction by a Gq alpha subunit-coupled receptor upon vascular smooth muscle cells (with downstream IP3-dependent mechanism causing a rise in intracellular Ca2+ to effect smooth muscle excitation-contraction coupling), thus acting to increase blood pressure.
== Medical uses == Repotrectinib is indicated for the treatment of adults with locally advanced or metastatic ROS1-positive non-small cell lung cancer. In June 2024, the US Food and Drug Administration (FDA) expanded the indication to include the treatment of people twelve years of age and older with solid tumors that have a neurotrophic tyrosine receptor kinase (NTRK) gene fusion, are locally advanced or metastatic or where surgical resection is likely to result in severe morbidity, and that have progressed following treatment or have no satisfactory alternative therapy.
== Career == After obtaining his undergraduate degrees, Wood started working on high-viscosity mucopolysaccharide fermentation development at CP Kelco in San Diego, California. Soon after, he joined Amgen in 1991, the same year that Amgen received FDA approval for Neupogen. This recombinant protein cytokine drug induces white blood cell production to fight infections in immunocompromised cancer patients after undergoing chemotherapy or radiation treatment. Wood worked on the GMP fermentation team to manufacture Neupogen (rhG-CSF) between 1991 and 1993. Neupogen became one of the most successful biotech drugs at that time and second blockbuster for Amgen after Epogen. In 1993, Wood joined the group of Georges Belfort as a Ph.D. student at Rensselaer Polytechnic Institute, where he worked primarily on mini-intein development for protein purification. During this time, he engineered the ∆I-CM intein, which was derived from Mycobacterium tuberculosis recA intein. After earning his Ph.D. he joined a team at Bristol Myers Squibb in Hopewell, New Jersey. This time he focused on the recovery and in vitro processing of transgenic monoclonal antibody therapeutics. In 2001, Wood started his academic career at Princeton University as an assistant professor of chemical and biological engineering, where he continued his research focusing on self-removing tags, protein engineering, and applied biosensors. In 2009, he joined the Chemical and Biomolecular Engineering Department at Ohio State University as an associate professor and soon after was appointed as a full professor.
Sources: en.wikipedia.org
电喷雾或基质辅助激光解吸电离质谱是常用手段，测得的质子化离子质荷比可换算为分子量。结果与理论值落在合理误差内，才支持结构一致的判断。
甲硫氨酸侧链含硫醚，在氧气、光照或金属离子存在时容易被氧化。氧化产物极性略增，常在色谱图上表现为主峰之前的肩峰或前伸峰。
通常建议冷藏避光，并在较短时间内使用。不存在适用于所有配方的统一期限，具体取决于浓度、缓冲体系与容器材质。
Solid peptide is best kept frozen at about minus 20 degrees Celsius in a sealed container with desiccant. It should be allowed to reach room temperature before opening to prevent condensation. Repeated warming and cooling of the same vial is discouraged.